alpos bay_tab_search_y btsy Platesetter_3244 If, when a pick command is issued, the picker moves back past the bay tab, the firmware deos an auto recovery by moving the picker forward (towards engine) again by the distance bay_tab_search_y. This distance must be less than the width of the bay tab. The firmware then moves the picker backwards until the back edge of the bay tab is detected. integer
  • 50000
    •
  • 0 to 75000 [mm]
    •      Note: When moving back searching for the back edge of the bay tab, the inherent latency in the response time of the firmware causes the autoloader to stop between 18 & 35 mm beyond (aft of) the back edge of the bay tab, rather that exactly on the back edge as intended. cal
  • ../nvs/bay_cal_loc.xmlNVS: bay loc
  • ../nvs/alpos_cal_ccy.xmlNVS: alpos ccy
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:19 2008 PST